HYATO98GBB

[ Pobierz całość w formacie PDF ]
SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00
www.cobra.it
HYUNDAI
ATOS
YEAR
98
fi
PETROL
DIESEL
X
MAKE
MOD.
ALARM/SIREN
POSITION
Position the compact alarms and the sirens in the engine compartment, on the
support of the shock absorber, passenger’s side.
POWER SUPPLY
+ 30:
connect to the general supply wiring in the general power supply connector of
the fuse box.
- 31:
connect with a terminal to one of the original bolts located behind the left
lateral panel, driver’s side.
IGNITION WIRE
+ 15/54:
connect to the 1,5 mm
2
YELLOW/RED wire located in the wiring harness
coming out of the 8 way black connector of the fuel pump relay located under the
glassholder consolle before the speed change lever.
DIRECTION INDICATORS
Connect to the 1 mm
2
GREEN/LIGHT BLUE and GREEN/YELLOW wires located
in the wiring harness coming out of the 20 way white connector located under the
dashboard, driver’s side.
ELECTRIC WINDOWS
Positive control signal
Front window, driver’s side:
cut the 1 mm
2
BROWN/RED wire located in the wiring harness coming out of the 7
way transparent connector directly connected to the control switch inside the
driver’s side door.
Front window, passenger’s side:
cut the 1,5 mm
2
BLUE/WHITE wire located in the wiring harness of the 21 way
white/yellow connector directly coming out of the driver’s side door behind the left
lateral panel.
CENTRAL DOORS LOCKING Additional motor
it is necessary to install an additional motor in the driver’s side door as it is
unprovided with actuating device.
IMMOBILISATION POINT
Fuel pump
Cut the 1,5 mm
2
YELLOW/RED wire located in the wiring harness coming out of
the 8 way black connector of the fuel pump relay located under the glassholder
consolle before the speed change lever.
STARTER
+50:
Cut the 2,5 mm
2
BLACK/YELLOW wire located in the wiring harness coming
out of the 6 way black/blue connector under the steering column.
BONNET SWITCH
Install an additional switch on the headlamp support plate, in correspondence with
the left lateral lamp, passenger’s side.
DOORS SWITCH
Connect to the 0,75 mm
2
BLUE/BLACK wire located in the wiring harness coming
out of the front left sill cover and going towards the rear of the vehicle.
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.
hyato98gbb.doc
[ Pobierz całość w formacie PDF ]

zanotowane.pl

doc.pisz.pl

pdf.pisz.pl

chiara76.opx.pl